Engine Bolts / Studs

Stomski Racing SR024 Through bolt o-ring installer with sleeve for Porsche 911



Based on the factory P9511 tool, STOMSKI RACING's version of this tool incorporates a brass cap and a double-ended stainless steel sleeve to install the o-rings on the crankcase through-bolts of the 3.6 and later cases (but possibly can be used on some other 911 engines). By using the included brass cap to protect the delicate o-ring from getting cut on the threads of the bolt, you then use the "thin" end of the sleeve to slide the o-ring over the brass cap onto the shank of the through-bolt. Once the o-ring is clear of the threads, remove the SR024 brass cap and flip the SR024 stainless steel sleeve over and use the blunted end to securely and gently seat the o-ring in the recess on the 3.6 case.

High performance stud + nut kits for the exhaust manifold to cylinder head for Porsche. Using titanium and Inconel alloy studs, aerospace lock nuts, and a well-thought and balanced combination of metals and plating/coatings, our fasteners will perform better than the traditional fastener. They will never oxidize, and hence will unscrew easily when required.



Novel ultra-high-performance product
• Use of Titanium Ti6Al4V technology
• Extreme perceived quality

Contains 12 x Studs, Nuts & Washers

Fits:
Porsche 911 3.0L SC
Porsche 911 3.2L 1984-89
Porsche 930 turbo
Porsche 965 turbo

Related reference numbers
Related, superseded, cross reference or alternative numbers for comparison.

SL-TI-122

The product you are viewing cross references to these numbers