Crankshaft & Parts

Speedi Sleeve for Crank Pulley Sealing Surface. Fits 911 1974-89 , 930



Fits: Crankshaft Pulley End

Fits:
Porsche 911 1974-89
Porsche 930 Turbo

Speedi Sleeves to Repair Worn, Grooved Seal Surfaces

Over time, sealing surfaces will become grooved, making a good seal impossible.The most economical and fastest method of shaft repair is to install the CR Speedi Sleeve. Speedi Sleeve is a precision engineered piece of stainless steel. It's ultra-thin wall design allows it to be used without changing the sel size ans its finish is perfect for lip sealing applications. Speedi Sleeve is built with removable installation flange. The installation tool included in every box allows the seal to be put in. This avoids the possibility of distortion from heat or other installation methods.

Related reference numbers
Related, superseded, cross reference or alternative numbers for comparison.

91110299189

The product you are viewing cross references to these numbers

Through bolt o-ring installer for Porsche 911



Installing O-rings on the through bolts for a 911 engine case often slices the rings on the threads of the bolt, leading to ripped seals at best, or a leaky engine at worst. Use this cap to protect the O-ring and to insure a factory quality seal. Precisely machined from quality brass.

Stomski Racing SR024 Through bolt o-ring installer with sleeve for Porsche 911



Based on the factory P9511 tool, STOMSKI RACING's version of this tool incorporates a brass cap and a double-ended stainless steel sleeve to install the o-rings on the crankcase through-bolts of the 3.6 and later cases (but possibly can be used on some other 911 engines). By using the included brass cap to protect the delicate o-ring from getting cut on the threads of the bolt, you then use the "thin" end of the sleeve to slide the o-ring over the brass cap onto the shank of the through-bolt. Once the o-ring is clear of the threads, remove the SR024 brass cap and flip the SR024 stainless steel sleeve over and use the blunted end to securely and gently seat the o-ring in the recess on the 3.6 case.