Side sill panel end cap single part. Porsche 911 1974-89  ❭  91155914104

Side sill panel end cap single part.
This OE Match side sill panel end cap is an exterior body trim component designed for Porsche 911 models produced between 1974 and 1989, including Turbo (930) variants. This part fits at the end of the rocker / side sill trim, completing the side sill moulding and providing a finished appearance to the lower body panel.
Sold each, Fits: RIGHT FRONT or LEFT REAR of the sill

Fits:
Porsche 911 1974 - 1989
Porsche 911  Turbo   1975 - 1989 

Diagram ref no 31 or 32

The side sill panel end cap is a small trim piece located at the front or rear end of the rocker panel trim on classic Porsche 911 models. It covers and protects the exposed end of the sill moulding, creating a clean transition between the body panels and the rocker trim.

Theis OE Match end cap is designed to match the original Porsche design used on the G-series 911. It is installed as part of the sill trim assembly and helps maintain the authentic appearance of the vehicle’s lower bodywork.

This component is commonly replaced during body restoration, sill trim refurbishment or repair of damaged rocker mouldings.

Side sill trim components are exposed to road debris, weather and general wear. Over time the end caps can crack, fade or become damaged, leaving the sill trim unfinished and exposed. Replacing them restores the proper appearance of the rocker trim and protects the underlying bodywork.

Consider replacing the sill end cap if you notice:
•  Missing or damaged rocker trim end pieces
•  Cracked or faded plastic end caps
•  Loose sill trim components
•  During classic Porsche body restoration

Related reference numbers
Related, superseded, cross reference or alternative numbers for comparison.

91155914104

The product you are viewing cross references to these numbers