Side Sill Moulding + Rubber Seal. Porsche 911 1969-73  ❭  90155910553

Side Sill Moulding + Rubber Seal.
It is a wide type decorative sill panel with a rubber insert that was fitted to the long wheelbase Porsche 911 from 1969 through 1973. The moulding is sized to approximately 59.5″ long and fits either left or right side of the vehicle. This exterior body-trim part sits along the lower rocker (side sill) area below the doors

Fits:
Porsche 911 1969-73 (LWB)
Long Wheel Base Cars

Diagram Ref No. 25

The side sill moulding serves both aesthetic and protective roles on the vehicle’s lower bodywork:
• Protects the rocker panel from minor impacts, road debris, and scrapes
• Accentuates the classic body line, contributing to the vehicle’s period-correct look
• The rubber seal helps bridge the gap between the trim and body, reducing moisture ingress behind the moulding and offering a more finished appearance
• Helps maintain authentic exterior style on restored or well-maintained classic vehicles.

Over decades on the road, original sill mouldings and seals can:
• Fade, crack, or warp
• Lose adhesion or proper fit
• Expose underlying rocker panels to corrosion or damage.

Replacing worn or missing sill trim restores the correct visual line and offers renewed protection for the lower bodywork - especially important on restored vehicles or those being prepared for show-quality presentation.

Replace this side sill moulding if:
•  The original trim is missing, cracked, split, or faded
•   Rubber insert has hardened or detached
•   Re-assembling after bodywork or repaint
•   During a body restoration or concours detailing project

Related reference numbers
Related, superseded, cross reference or alternative numbers for comparison.

90155910553

The product you are viewing cross references to these numbers