Radiator oil cooler rubber buffer, SET OF 3. Porsche 911 1984-89

Radiator oil cooler rubber buffer, SET OF 3
This replacement buffer is a high-quality replacement for the factory bonded-rubber mounts used to support the oil cooler assembly in air-cooled Porsche engines. It helps isolate vibration, maintain correct alignment, and protect the cooler and adjoining hardware.

Fits:
Porsche 911 1984 - 1989

Diagram Ref No 14.

This is a rubber buffer or mount (often bonded to metal inserts) used to cushion and secure the oil cooler assembly relative to the engine or chassis. It absorbs vibration, prevents metal-to-metal contact, and keeps the cooler in its correct position. It helps avoid stresses on oil cooler brackets, lines, and mating surfaces by providing a flexible mounting point.

Replaces: Porsche 930.207.239.00 / 930.207.239.01 / 930.207.239.02
Position: Between oil cooler and engine or chassis mount — isolates vibration and supports alignment
Function: Absorbs vibration and engine movement, prevents stress on oil cooler lines and brackets
Installation: Direct-fit OE replacement — install as a set for best results
Maintenance Tip: Replace when rubber hardens, cracks, or separates from metal housing

Over time, the rubber in the buffer mount degrades due to heat, oil exposure, ozone, vibration, and fatigue. It may harden, crack, shrink, or separate from its bonded metal insert. A failed mount lets the oil cooler shift or vibrate more than designed, putting strain on cooler hoses, brackets, and mounting flanges — potentially leading to leaks or damage. Excessive vibration may cause noise, misalignment, or premature fatigue of supporting parts. You should replace this buffer when you notice damage or deterioration, when removing or servicing the oil cooler, or as preventive maintenance on high-mileage engines.

Related reference numbers
Related, superseded, cross reference or alternative numbers for comparison.

93020723902

The product you are viewing cross references to these numbers