Transmission gearbox teeth. Dog teeth 2nd gear. Porsche 911 1974-86 (915 Gearbox)  ❭  91530224200

Transmission gearbox teeth. Dog teeth 2nd gear. 
G915 up to 1975 1st gear  /  G915 1976>> 2nd. gear

Fits:
Porsche 911 1974-86 (915 Gearbox)

Dog Teeth 2nd Gear 911 1972-86 Symmetrical Tooth Point, 1 slot in hub (915 Trans. 1972-86)

Diagram Ref no 35.

A dog-teeth gear (or synchronizer-gear hub / 1st-2nd gear dog gear) used inside the 915 gearbox. This gear section engages with corresponding hub or clutch-dog components to allow shifting between gears - in particular 1st and/or 2nd gear depending on the configuration.

Gears inside classic 915 transmissions - especially dog / synchronizer-gears - are subject to wear over time: tooth heads can round off, suffer chip-out, or distort under load; synchronizer engagement surfaces may wear and lose precision. This can cause:
• Gear-slip or missed shifts
• Grinding or clash during shifting
• Torque transmission loss or vibration under load
• Accelerated wear of other transmission internals.
Replacing worn gears with a precisely machined, correctly hardened OE-match replacement restores gear-mesh integrity, retains gearbox performance, and helps avoid costly gearbox failure.

When to Replace.
Consider fitting this gear if:
• You hear grinding, clash, or crunching during shifting - especially into 1st or 2nd gear
• Gearbox inspection reveals worn, rounded, chipped, or damaged dog-teeth or synchronizer surfaces
• You are performing a full gearbox rebuild or overhaul
• The gearbox has high mileage or signs of internal wear
•  You want to restore factory-spec shifting performance and reliability

Related reference numbers
Related, superseded, cross reference or alternative numbers for comparison.

91530224200

The product you are viewing cross references to these numbers