Rohler

This kit is a modern update to the 911 3.2 ignition system and brings the management of the car into the digital age to allow greater control over ignition and fueling.

The kit replaces your restrictive old fashioned air flow meter (barn door) with a modern map sensor managed by intake pressures.

The kit gives many driving benefits, better/smoother power delivery, better throttle response, eliminates lots of the low-down idle problems as it now uses a throttle position sensor and delivers more torque and BHP.

The kit is delivered ready to use with a PPT ignition map for the 3.2 standard engine management; however, the kit can be mapped for different cams and engine capacity increase.

Our latest kit now comes with an upgraded ECU and can run a wide band sensor (oxygen sensor).
Our kits include this capability but the sensor needs to be ordered separately.

While developing the upgraded ECU we have also changed our intake pipe; this now works with the factory airbox, gives a stock appearance in the engine bay and houses the map sensor and air temp sensor out of sight.

Kits includes:
• Delta 700 ECU
• 2 x Direct plug-in wiring looms
• Map Sensor and air temp sensor
• Air intake pipe, gasket, and bolts
• 6 Bosch injectors
• Vacuum pipe and T connector
• Throttle Position Sensor (TPS) and adaptor
• Support and service by PIE Performance
• Can Bus data connection tool

All our kits are 100% reversible, with no need to drill or alter components, we utilise what already exists

This kit is a modern update to the 964 (911) ignition system. This system takes the management of the car into the digital age and allows greater control over ignition and fueling.

The kit will replace your restrictive old fashioned air flow meter (barn door) with a modern MAP sensor managed by intake pressures.

The kit is delivered ready to use with a PPT ignition map. We have maps for 3.6 and 3.8 conversions, and either can be pre-installed for you.

Our latest kit now comes with an upgraded ECU and can run a wide band sensor (oxygen sensor).
Our kits include this capability but the sensor needs to be ordered separately.

While developing the upgraded ECU we also changed our intake pipe; this now works with the factory airbox, gives a stock appearance in the engine bay and houses the map sensor and air temp sensor out of sight.

Kit includes:
• Delta 700 ECU
• Direct plug in wiring loom
• Map Sensor and air temp sensor
• Air intake pipe
• 6 Bosch injectors
• Vacuum pipe and T connector
• Support and service by PIE Performance
• Can Bus data connection tool

All our kits are 100% reversible, with no need to drill or alter components, we utilise what already exists

Please note: As an option, you can add rubber boot protectors (at the basket stage) to seal the bearing from any road grime and debris. 
Shown on the picture in the gallery but not included in the price of the top mounts. Sold as each. 2 required.

Please note: As an option, you can add rubber boot protectors (at the basket stage) to seal the bearing from any road grime and debris. 
Shown on the picture in the gallery but not included in the price of the top mounts. Sold as each. 2 required.